Disassembly and Installation of M9 breast pump

This article contains the following sections:

• Disassembly for Cleaning
• Assembly for Use

1.Disassembly for Cleaning:

To ensure proper hygiene, it's essential to disassemble your M9 breast pump after each use for thorough cleaning.

1.Disassemble the main unit and flange assembly.
2.Pull the flange upwards to separate it from the milk collector.
3.Open the cap by rotating it in the direction of the unlock icon at the mouth of the bottle.
4.Remove the diaphragm assembly from the flange.

---

Important Caution: Never put the main unit, charging cable, or the adapter (if you've purchased one) in water or a dishwasher, as this will cause permanent damage to these parts.

---

2.Assembly for Use:

Before assembling, ensure all parts that come into contact with milk or your breast have been thoroughly cleaned and disinfected. Be careful, when you have disinfected the breast pump parts by boiling them, they can be very hot. To prevent burns, only start assembling the breast pump when disinfected parts have cooled down. Always wash your hands thoroughly with soap and water before you touch breast pump parts and breasts to prevent contamination. Avoid touching the inside of milk collection set.

Here are the assembly steps:

1.Wash your hands thoroughly with soap and water.
2.Assemble the milk bowl by rotating it in the direction of the lock icon at the mouth of the bottle.
3.Fasten the flange to the mouth of the bottle and assemble with the milk collector.
4.Assemble the main unit and flange.

Your breast pump is now ready for use!